140CPS12400R 电源模块 提供系统电源所必需的

【产品详情】

Modicon 140 CPS 124 00 电源模块是向插入 Modicon Quantum 系统机架面板上的模块提供系统电源所必需的。施耐德电气电源单元 140 CPS 124 00 为哪些模块供电？140 CPS 124 00 为 Modicon Quantum CPU 模块、接口模块和 Modicon Quantum I/O 模块分配电源。昆腾 CPU 模块、接口模块和 Modicon I/O 模块必须与 Modicon 140 CPS 124 00 一起插入机架，才能从电源模块接收电源。

操作模式：独立和冗余

内部功耗（电损耗）：9 W

网络功耗：电损耗 + （5.1 x Iout）¹

功率因数：0.5

Modicon 140 CPS 124 00 的输入功能如下。输入电压为 93 ...138 VAC 和 170 ...276 伏交流电输入频率为 47 ...63赫兹。该电源模块的输入电压总谐波失真小于基波 RMS 值的 10%。本机的输入电流为 1.1 A @ 115 VAC，0.6 A @ 230 VAC。140 CPS 124 00 的浪涌电流为 38 A @ 115 VAC，19 A @ 230 VAC。该模块的额定 VA 为 130 VA，140 CPS 124 00 的外部熔断器为 2.0 A 慢熔断。输入电源中断是满载和最小额定线路电压和频率下的半周期。

总线信息的输出如下。独立最大电流为 5.1 VDC，两个 140 CPS 124 00 模块的最大冗余电流为 8 A（60°C）。 在机架上使用 3 140 个 CPS 124 00 模块时，60°C 时的独立最大电流为 16 A。 在机架上使用一台 140 CPS 124 00 和一台 140 CPS 524 00 时，60°C 时的独立最大电流为 8 A。 一个 140 CPS 124 00 和两个 140 CPS 524 00 的独立最大电流在 60°C 时为 16 A。 在60°C时，两个140 CPS 124 00和一个140 CPS 524 00的独立最大电流为16 A。 没有最小电流要求。总线的输出具有过流保护和过压保护。

140CPS12400R 电源模块 提供系统电源所必需的

【英文介绍】

The Modicon 140 CPS 124 00 Power module is necessary to provide system power to the module plugged into the Modicon Quantum system rack panel. Schneider Electric Power Unit 140 CPS 124 00 Which modules are powered? 140 CPS 124 00 Allocates power to the Modicon Quantum CPU module, interface module, and Modicon Quantum I/O module. The Quinten CPU module, interface module, and Modicon I/O module must be inserted into the rack along with the Modicon 140 CPS 124 00 to receive power from the PSU.

Operation mode: Independent and redundant

Internal power consumption (electrical loss) : 9 W

Network power consumption: Electrical loss + (5.1 x Iout) ¹

Power factor: 0.5

The input functions of the Modicon 140 CPS 124 00 are as follows. Input voltage is 93... 138 VAC and 170... 276 volts AC input frequency is 47... 63 Hertz. The total harmonic distortion of the input voltage of the power module is less than 10% of the fundamental RMS value. The input current of this machine is 1.1A@115VAC, 0.6A@230VAC. The surge current for 140 CPS 124 00 is 38 A @ 115 VAC, 19 A @ 230 VAC. The module has a VA rating of 130 VA and the external fuse of 140 CPS 124 00 is 2.0A slow fuse. Input power outages are half cycles at full load and minimum rated line voltage and frequency.

The output of the bus information is as follows. The independent maximum current is 5.1 VDC and the two 140 CPS 124 00 modules have A maximum redundant current of 8 A (60°C). When using 3 140 CPS 124 00 modules on the rack, the independent maximum current at 60°C is 16 A. When using one 140 CPS 124 00 and one 140 CPS 524 00 on the rack, the independent maximum current at 60°C is 8 A. The independent maximum current of one 140 CPS 124 00 and two 140 CPS 524 00 is 16 A at 60°C. At 60°C, the independent maximum current of two 140 CPS 124 00 and one 140 CPS 524 00 is 16 A. There is no minimum current requirement. The output of the bus has overcurrent protection and overvoltage protection.

140CPS12400R 电源模块 提供系统电源所必需的

【其他型号推荐】