140CRP81100 接口模块 I/O 模块

【产品详情】

部件号 140CRP81100

制造者 施耐德电气

类型 I/O 模块

型# 140-CRP-811-00

保证 2 年

带冗余电缆的 RIO 拓扑：当系统上的每个 I/O 断开时，需要 MA0185100 T 连接器。原因是您必须将跌落与干线电缆电气隔离。这样，您的系统就可以获得保护，防止阻抗不匹配以及电缆断开。您必须在每次 I/O 丢弃和中继电缆之间保持 14 分贝的最小信号强度。当中继电缆穿过 T 型连接器时，信号损失为 1 分贝。您可以从 RIO CPU 的头部总共提供 35 分贝。整个电缆架构不允许超过该限制。

用作独立设备的光纤中继器：光纤中继器模块格式为 Quantum，因此它可以用作独立设备，在具有三个插槽的机架中具有单个电源。例如，当您更换与中继器完全兼容的中继器时。您可以将它们直接合并到昆腾机架中。这将为您提供更紧凑的冗余电源配置。

140CRP81100 接口模块 I/O 模块

【英文介绍】

Part number 140CRP81100

Manufacturer Schneider Electric

Type I/O module

Type # 140-CRP-811-00

Guaranteed for 2 years

RIO topology with redundant cables: MA0185100 T connectors are required when every I/O on the system is disconnected. The reason is that you must electrically isolate the drop from the main cable. This way, your system is protected against impedance mismatches and cable disconnections. You must maintain a minimum signal strength of 14 decibels between each I/O drop and the trunk cable. When the relay cable passes through the T-connector, the signal loss is 1 dB. You can deliver a total of 35 dB from the head of the RIO CPU. The entire cable architecture is not allowed to exceed this limit.

Fiber repeater used as a standalone device: The fiber repeater module is in the Quantum format, so it can be used as a standalone device with a single power supply in a rack with three slots. For example, when you replace a repeater that is fully compatible with the repeater. You can incorporate them directly into the Quinten rack. This will give you a more compact and redundant power supply configuration.

140CRP81100 接口模块 I/O 模块

【其他型号推荐】