SCXI-1192 SPDT继电器模块 有 2 个通道

【产品详情】

National Instruments SCXI-1192 继电器模块

SCXI-1192 通用 18 GHz 模块可以处理最高 18 GHz 的射频信号。该模块有 8 个 SPDT 继电器，每个继电器有 2 个通道，不支持将信号路由到高压模拟总线。模块的最大额定电压为 30 V，而 30 V 时的最大额定电流为 2 A。对于NI SCXI-1192和其他SCXI模块，用户可以选择自动检测模块或手动添加模块。选择基于用户的应用程序。当用户选择自动检测且机箱不是SCXI-2000远程机箱时，用户必须确保机箱已连接到NI仪器。必须记住不要将SCXI 1192继电器模块从已通电的机箱中取出。否则可能会损坏模块。

NI SCXI-1192 有 24 个 用于 I/ O 连接器 的 插 孔。该模块上的继电器是带有镀金触点材料的闭锁机电继电器。由于该继电器模块具有闭锁继电器，因此没有定义的上电状态。相反，继电器将在断电的情况下保持其状态。SCXI-1192的静止模式将每个继电器的NC连接到COM。此外， NI SCXI-1192 还 可用于 将 信号 从 两个 RF 源 路由 到 一个 RF 测量 仪器。这些测量仪器包括示波器、频谱分析仪或功率计。

SCXI-1192 SPDT继电器模块 有 2 个通道

【英文介绍】

National Instruments SCXI-1192 Relay module

The SCXI-1192 Universal 18 GHz module can handle RF signals up to 18 GHz. The module has 8 SPDT relays with 2 channels each and does not support signal routing to the high voltage analog bus. The maximum rated voltage of the module is 30 V, while the maximum rated current at 30 V is 2 A. For NI SCXI-1192 and other SCXI modules, users can choose to automatically detect modules or manually add modules. Select a user-based application. When the user chooses automatic detection and the case is not a SCXI-2000 remote case, the user must ensure that the case is connected to the NI instrument. Remember not to remove the SCXI 1192 relay module from a powered case. Otherwise, the module may be damaged.

The NI SCXI-1192 has 24 slots for I/ O connectors. The relay on the module is a latching electromechanical relay with gold-plated contact material. Since this relay module has a latching relay, there is no defined power-on state. Instead, the relay will maintain its state in the event of a power outage. The static mode of the SCXI-1192 connects the NC of each relay to the COM. In addition, the NI SCXI-1192 can be used to route signals from two RF sources to a single RF measuring instrument. These measuring instruments include oscilloscopes, spectrum analyzers or power meters.

SCXI-1192 SPDT继电器模块 有 2 个通道

【其他型号推荐】