2198-ABQE 输出仿真器模块 具有安装支架

【产品详情】

2198-ABQE 模块是由 Allen-Bradley/Rockwell Automation 在 2198 产品线中设计的编码器输出仿真器模块。该模块的主要目标是将脉冲编码到外围设备，然后通过使用网络的集成运动来支持系统的实轴和虚轴，在这种情况下，网络是以太网/IP 网络。Allen-Bradley/Rockwell Automation 2198-ABQE 编码器输出仿真器模块随附一个 24 伏接线插头、用于记录 IP 地址的标签和安装说明。连接器套件、备用连接器和端到端锚固件组等一些物品需要单独订购，正确安装模块也需要这些物品。安装模块时，请务必了解驱动器顶部和下方必须留出至少 100 毫米的间隙，但模块侧面不需要间隙。

Allen-Bradley/Rockwell Automation 2198-ABQE 编码器输出仿真器模块具有安装支架、安装闩锁和安全接地点。该模块旨在安装在DIN导轨上，首先需要固定然后固定。该模块的一些功能和指示灯包括一个 IP 地址开关、一个安装闩锁、两个 15 针输出连接器（称为连接器 A 和 B）和 e 以太网端口。Allen-Bradley/Rockwell Automation 2198-ABQE 编码器输出仿真器模块带有网络和模块状态指示灯，以及链路速度和链路/活动状态指示灯。该模块具有控制输入电源 （CP） 连接器电压额定值为 24 伏。

2198-ABQE 输出仿真器模块 具有安装支架

【英文介绍】

The 2198-ABQE module is an encoder output emulator module designed by Allen-Bradley/Rockwell Automation in the 2198 product line. The main goal of the module is to encode pulses to peripherals and then support the real and virtual axes of the system by using the integrated motion of the network, which in this case is an Ethernet /IP network. The Allen-Bradley/Rockwell Automation 2198-ABQE encoder output emulator module comes with a 24-volt plug, label for recording IP addresses, and installation instructions. Some items, such as connector kits, spare connectors, and end to end anchor kits, need to be ordered separately, as well as properly installed modules. When installing the module, it is important to understand that a gap of at least 100 mm must be left between the top and bottom of the drive, but no gap is required on the side of the module.

Allen-Bradley/Rockwell Automation 2198-ABQE encoder output emulator module with mounting mount, mounting latch and safe ground point. The module is designed to be mounted on a DIN rail, which first needs to be secured and then secured. Some of the module's features and indicators include an IP address switch, A mounting latch, two 15-pin output connectors (known as connectors A and B), and e Ethernet ports. Allen-Bradley/Rockwell Automation 2198-ABQE encoder Output emulator module with network and module status indicators, as well as link speed and link/activity status indicators. The module has a control input power (CP) connector voltage rating of 24 volts.

2198-ABQE 输出仿真器模块 具有安装支架

【其他型号推荐】