ABB PPC905AE101 3BHE014070R0101 控制器模块

ABB PPC905AE101 3BHE014070R0101  控制器模块

ABB PPC905AE101 3BHE014070R0101  控制器模块

ABB PPC905AE101 3BHE014070R0101  控制器模块连接应由经验丰富的人员完成，以免损坏驱动器，并且在进行连接之前，驱动器和电线必须与电源断开连接（如果已连接）。输入和电机连接可以在驱动器中看到。

连接三相电源的输入部分。U1、V1、W1为输入接线，本节我们可以接三相电源。在右侧，我们可以看到用于连接电机的 U2、V2 和 W2。在上图中，如果我们查看输入电源部分，我们可以看到 I/O 条，我们可以看到一个可用于选择电压和毫安信号的开关。因此，如果我们要使用电位器并且需要电压信号，我们可以设置为 U。之后就可以连接电位器了，如下图所示。

之后，我们可以连接按钮，这样做我们只需要将电线连接到一个连接。之后我们可以连接数字输入，以便可以维护开关，我们可以使用不同颜色的导线，这样我们就可以知道哪个开关连接到特定的输入。

ABB PPC905AE101 3BHE014070R0101  控制器模块连接 COM 和 GND 端子后，我们可以将电线连接到 24 V 端子，这将通过源为连接提供电源。之后，我们可以通过为驱动器供电来检查连接。然后根据数字输入连接和驱动器中的参数，我们可以运行电机。我们可以检查电机的启动和停止，然后可以完成电机的正转和反转检查。我们还可以检查电机可以运行的恒定速度，这只能通过设置驱动器参数来实现。然后我们还可以做电机的加减速测试。在图像的右侧，我们可以看到三个IOS，它们用于继电器输出，指示灯可以用来指示这里的故障。

ABB PPC905AE101 3BHE014070R0101  控制器模块

ABB PPC905AE101 3BHE014070R0101 Controller module connection should be done by an experienced person so as not to damage the drive, and the drive and wires must be disconnected from the power supply (if connected) before connection can be made. The input and motor connections can be seen in the drive.

Connect the input part of the three-phase power supply. U1, V1, and W1 are input cables. In this section, we can connect the three-phase power supply. On the right, we can see the U2, V2 and W2 used to connect the motor. In the image above, if we look at the input power section, we can see the I/O bar, and we can see a switch that can be used to select the voltage and the MA signal. So if we are going to use a potentiometer and need a voltage signal, we can set it to U. After that, you can connect the potentiometer, as shown below.

After that, we can connect the button, and in doing so we only need to connect the wire to a connection. After that we can connect the digital input so that the switch can be maintained, and we can use different colored wires so that we can know which switch is connected to a particular input.

After the ABB PPC905AE101 3BHE014070R0101 controller module is connected to the COM and GND terminals, we can connect the wire to the 24 V terminals, which will provide power to the connection through the source. After that, we can check the connection by powering the drive. Then according to the digital input connection and the parameters in the drive, we can run the motor. We can check the start and stop of the motor, and then we can complete the forward and reverse check of the motor. We can also check the constant speed at which the motor can run, which can only be achieved by setting the driver parameters. Then we can also do the acceleration and deceleration test of the motor. On the right side of the image, we can see three IOS, which are used for relay output, and the indicator light can be used to indicate the fault here.

ABB PPC905AE101 3BHE014070R0101  控制器模块

ABB UFC762AE101

ABB UFC718AE01

ABB UFC718AE01 HIEE300936R0001

ABB UFC718AE101

ABB UFC718AE101 HIEE300936R0101

ABB UFC719AE01

ABB UFC719AE01 3BHB003041R0001 3BHB000272R0001

ABB UFC719AE01 3BHB003041R0101 3BHB00072R0101

ABB UFC719AE101 3BHB003041R0101 3BHB00072R0101

ABB UFC721AE

ABB UFC721AE101 3BHB002916R0101

ABB UFC721BE101

ABB UFC721BE101 3BHE021889R0101

ABB UFC760BE142 3BHE004573R0142

ABB UFC760BE143 3BHE004573R0143

ABB UFC760BE42 3BHE004573R1042

ABB UFC911B106 3BHE037864R0106

ABB UFC911B108

ABB UFC911B108 3BHE037864R0108

ABB UFC911B110

ABB UFC921A101 3BHE024855R0101

ABB ABB UFC762AE101 3BHE006412R0101

ABB UFC762AE101

ABB ABB XVC767AE102 3BHB007209R0102

ABB XVC767AE105 3BHB007209R0105

ABB XVC7681023BHB007211R102

ABB XVC722AE1013BHB002751R0101

ABB XVC7681153BHB007211R115

ABB XVC7681013BHB007211R101

ABB XVC768102 3BHB007211R102

ABB XVC724BE101 3BHE009017R0101

ABB XVC769AE101 3BHE006373R0101

ABB XVC770BE101 3BHE021083R0101

ABB XVC77OBE101 3BHE021083R0101

ABB ABB XVC768101 3BHB007211R101

ABB ABB GDB021BE01 HIEE300766R0001

ABB ABB LD800HSE

厦门雄霸电子商务有限公司主营(DCS系统) (机器 人系统)

(大型伺服控制系统)模块备件的销售。公司经营范围:分布式控制系统

(DCS)、可编程序控制器(PLC)、MOTOROLA MVME工业用模组、工业控制通訊

转换器(ANYBUS)、远端输出/输入模块(RTU)、工业电脑(IPC)、工业用低頻萤

幕(IPC)、人机界面SCSI(50、68、80PIN) ANYBUS(GATEWAY)。厦门雄霸从事

工控行业十几年，现已成- -家工业自动化备件及零部件的销售企业。我司能直

接从境外进货、能够提供不同国别、厂商的设备以及备件、解决您多处寻找的麻

烦或对产品质量问题的担心等、在价格上我们有很大的优势。竭诚欢迎您来电查

询或使用E-MAIL查询!所需产品品牌+型号+数量+贵司具体名称/电话/传真/联系

人，我们将尽快给您提供报价!