8404-203 集成速度控制  需要特定的电流容量

【产品详情】

8404-203 型号是 ProAct 集成速度控制 （PISC）。这是PISC模型中的第一个。安装模型时，它将安装在阀法兰上，需要四个 M8 螺钉才能正确安装。螺钉应拧紧，完成后应为 200 磅英寸。PISC模型接地时，应将其接地到发动机结构上，以确保不会发生错误，通过低阻抗连接将设备接地，以确保适当的EMC性能。

8404-203 型号将在 18 至 32 伏直流电的电压源下运行，但需要特定的电流容量。 与 8404-203 型号相关的当前容量为 5 A。当模型及其发动机启动时，启动电压至少为 8，但在第一分钟内可能高达 40 V。

请注意，本设备的输入电源必须熔断，如果未在 5 A 快速熔断下熔断，在特殊情况下，无法熔断 PISC 型号可能会导致爆炸、控制阀损坏或导致人身伤害。

在 8404-203 型号的操作和安装过程中，最好使用的手册是 ProAct ISC 集成速度控制执行器型号 26246 用户指南。本手册包含有关PISC I模型所需的所有信息。

8404-203 集成速度控制  需要特定的电流容量

【英文介绍】

Model 8404-203 is ProAct Integrated Speed Control (PISC). This is the first in the PISC model. When installing the model, it will be mounted on the valve flange and requires four M8 screws to install properly. The screw should be tightened and should be 200 pound-inches when finished. When the PISC model is grounded, it should be grounded to the engine structure to ensure that no errors occur, and the device should be grounded via a low impedance connection to ensure proper EMC performance.

The 8404-203 model will operate at a voltage source of 18 to 32 volts DC, but requires a specific current capacity. The current capacity associated with model 8404-203 is 5 A. When the model and its engine are started, the starting voltage is at least 8, but it can be as high as 40 V in the first minute.

Please note that the input power supply to this device must be blown, and failure to fuse the PISC model under 5 A quick fuse may result in explosion, damage to the control valve, or personal injury under special circumstances.

The best manual to use during the operation and installation of model 8404-203 is the ProAct ISC Integrated Speed Control Actuator Type 26246 User Guide. This manual contains all the information you need about the PISC I model.

8404-203 集成速度控制  需要特定的电流容量

【其他型号推荐】