Woodward 8235-360 执行器和驱动器 支撑节气门组件
【产品详情】
伍德沃德 8235-360 型是 ProAct 和 ProAct Plus 系列执行器和驱动器中的型号之一。该型号与PISC III执行器一起使用。在正常运行期间执行时，执行器将在 18 到 32 VDC 的范围内运行，当启动或瞬态时，模型将在 8-40 VDC 下运行至少一分钟。安装时，需要连接硬件以及所需的支架来支撑节气门组件的重量，并且必须承受与发动机安装相关的振动。
当使用所选调速器操作 8235-360 型号并发生故障排除错误时，可以通过谨慎并重复校准程序来纠正有关调速器的任何问题。如果需要，尝试将调速器与发动机隔离，以评估调速器内部是否发生了问题，而不是发动机或发动机本身的负载。有关调速器的任何故障通常发生在安装后。
如果需要对 8235-360 或 PISC III 执行器进行任何调整，可通过 ProAct ISC（集成速度控制）维修工具进行调整。该工具在个人计算机上运行，将通过串行连接与PISC通信，当不使用控件时，该工具将断开连接。
虽然PISC III型号可用于启动发动机停机，但请注意，它不应是主要的停机机制。有关系统操作、安装、故障排除等的所有信息都可以在伍德沃德 26246 和 26265 手册中找到。26265 手册包含有关 8235-360 的信息，26246 手册包含有关 PISC 执行器的信息。
Woodward 8235-360 执行器和驱动器 支撑节气门组件
【英文介绍】
The Woodward Model 8235-360 is one of the models in the ProAct and ProAct Plus series of actuators and drives. This model is used with PISC III actuators. When executed during normal operation, the actuator will run in the range of 18 to 32 VDC, and when started or transient, the model will run at 8-40 VDC for at least one minute. When installing, the hardware needs to be attached as well as the brackets required to support the weight of the throttle assembly and must withstand the vibrations associated with engine installation.
When operating the 8235-360 model with the selected governor and troubleshooting errors occur, any problems with the governor can be corrected by being careful and repeating the calibration procedure. If needed, try to isolate the governor from the engine to assess whether there is a problem occurring inside the governor, rather than the load on the engine or the engine itself. Any failure with the governor usually occurs after installation.
If any adjustments need to be made to the 8235-360 or PISC III actuators, they can be made via the ProAct ISC (Integrated Speed Control) service tool. The tool, which runs on a personal computer, will communicate with the PISC via a serial connection, and the tool will disconnect when the controls are not in use.
While the PISC III model can be used to start an engine stop, please note that it should not be the primary stop mechanism. All information on system operation, installation, troubleshooting, and more can be found in the Woodward 26246 and 26265 manuals. Manual 26265 contains information about 8235-360 and manual 26246 contains information about PISC actuators.
Woodward 8235-360 执行器和驱动器 支撑节气门组件
【其他型号推荐】
| TRICONEX 4101 | Triconex DCS | DCS备件模块 | BENTLY 3500/20 125744-02T | DCS控制系统 | Bently Nevada |
| TRICONEX 3721 | Triconex DCS | 模拟量输入卡件 | BENTLY 3500/20 | 控制继电器 | Bently Nevada |
| TRICONEX 3701 | Triconex DCS | 卡件 | BENTLY 3500/15E | 风电备件 | Bently Nevada |
| TRICONEX 3700 | Triconex DCS | 扫描器 | BENTLY 3500/15127610-01S | 液压伺服模块 | Bently Nevada |
| TRICONEX 3664 | Triconex DCS | 输入输出模块 | BENTLY 3500/15127610-01 | 存储器模块 | Bently Nevada |
| TRICONEX 3625 | Triconex DCS | PLC中央处理器 | BENTLY 3500/15125760-01 | 数字信号输入输出模块 | Bently Nevada |
| TRICONEX 3624 | Triconex DCS | DO模块 | BENTLY 3500/15-05-05-00 | 伺服驱动 | Bently Nevada |
| TRICONEX 3511 | Triconex DCS | 控制处理器 | BENTLY 3500/15-05-00-00 | 安全继电器 | Bently Nevada |
| TRICONEX 3510 | Triconex DCS | 数字输入模件 | BENTLY 3500/15-02-02-00 | 绕线式 | Bently Nevada |
| TRICONEX 3451 | Triconex DCS | 开关量输入卡 | BENTLY 3500/15-02-00-00 | 处理器 | Bently Nevada |
| TRICONEX 3401 | Triconex DCS | 卡件 | BENTLY 3500/15-02-00 | 模件 | Bently Nevada |
| TRICONEX 3351 | Triconex DCS | DI卡件 | BENTLY 3500/15-01-01-00 | 交流伺服马达驱动器 | Bently Nevada |
| TRICONEX 3301 | Triconex DCS | DI卡件 | BENTLY 3500/15-01-00-00 | 模拟量输出模块 | Bently Nevada |
| TRICONEX 3201 | Triconex DCS | DI卡件 | BENTLY 3500/15 127610-01S | 网络接口从站模块 | Bently Nevada |
| TRICONEX 3101 | Triconex DCS | 增强型智能通信模件 | BENTLY 3500/15 125760-01 | HCU柜模件 | Bently Nevada |
| TRICONEX 3008 | Triconex DCS | 模拟量输入模块 | BENTLY 3500/15 | 多功能处理器端接模块 | Bently Nevada |
