8235-350 执行器/驱动器型号  带有集成速度控制

【产品详情】

伍德沃德型号 8235-350 是 ProAct 和 ProAct Plus 执行器和驱动器系列的一部分。他的具体型号是带有集成速度控制和集成节气门体的 ProAct 执行器。8235-350 型号要求支撑支架和电子元件闭合之间至少留有 0.5 mm 的间隙。这是必要的，因为外壳支撑在隔振器上，当支撑在这些隔振器上时，高频振动被过滤掉并防止到达电子设备。

虽然该模型需要模型III，但PISC II模型在功率要求方面与以前的PISC II模型没有区别。电源要求仍然是 18 至 32 VDC 的电压范围，并且电流容量至少为 15 A。熔断时，第三种型号与以前的型号不同，因为与较小的 20 A 快速熔断相比，它具有更大的快速熔断和 15 A 快速熔断。

8235-350 型号需要 O-Rngs 用于连接执行器的法兰上的凹槽。这些 O-Rngs 将是 Parker 2-255 Rngs。 安装本机时，建议将其安装为底座，这必须发生，因为执行器上的质量很高，并且重心和孔中心之间的杠杆臂增加。如果您对安装应用和技术错误有任何疑问，请参阅伍德沃德 26265 手册，这是该系列的主要手册。

8235-350 执行器/驱动器型号  带有集成速度控制

【英文介绍】

The Woodward model 8235-350 is part of the ProAct and ProAct Plus actuator and drive families. His specific model is a ProAct actuator with integrated speed control and integrated throttle body. Models 8235-350 require a gap of at least 0.5 mm between the support bracket and the closure of the electronics. This is necessary because the housing is supported on the isolators, and when supported on these isolators, high-frequency vibrations are filtered out and prevented from reaching the electronics.

Although this model requires Model III, the PISC II model does not differ from the previous PISC II model in terms of power requirements. Power requirements remain in the 18 to 32 VDC voltage range, with A current capacity of at least 15 A. When fusing, the third model is different from the previous model because it has A larger quick fusing and A 15 A quick fusing compared to the smaller 20 A quick fusing.

Models 8235-350 require grooves in the flanges of the O-Rngs for connecting the actuators. These O-Rngs will be Parker 2-255 Rngs. When installing this machine, it is recommended to mount it as a base, this must happen because of the high mass on the actuator and the increase in the lever arm between the center of gravity and the center of the hole. If you have any questions about installation applications and technical errors, please refer to the Woodward 26265 manual, which is the main manual in this series.

8235-350 执行器/驱动器型号  带有集成速度控制

【其他型号推荐】