Woodward 8256-089 执行器 电动调速器

【产品详情】

8256-089 型是电动调速器系列中的伍德沃德执行器。将该产品与速度控制和磁性拾音器一起使用将创建一个完整的 EPG 系统。该执行器将消耗最大 60 瓦的功率。它的额定速度调节为 25 圈电位器。该产品由 12 伏电池供电，最小电源为 10 VDC，最大电源为 16 VDC。执行器的电线长度将根据使用的电线和连接方式而有所不同。

从电池到控制器的接线距离为 35 到 30 英尺，具体取决于使用的是 14 AWG 还是 12AWG 电线。12 AWG 将允许 20 英尺的距离。从执行器到控制器的电线长度可以从 25 英尺到 10 英尺不等。12 AWG 的距离为 25 英尺，而 14 AWG 只能达到 10 英尺长。如果电线长度超过预期长度，则可能导致执行器无法正常工作。产品 8256-089 设计用于原动机，可安装在发动机附近。执行器的环境温度不应高于 200 华氏度。型号 8256-089 已由伍德沃德停产，但可通过 AX 控制找到。AX Control 可以维修、购买和销售这些产品。

Woodward 8256-089 执行器 电动调速器

【英文介绍】

Model 8256-089 is a Woodward actuator in the electric governor family. Using this product with speed control and magnetic pickups will create a complete EPG system. The actuator will consume up to 60 watts of power. Its rated speed is adjusted to 25 turns potentiometer. The product is powered by a 12-volt battery with a minimum power supply of 10 VDC and a maximum power supply of 16 VDC. The length of the actuator wire will vary depending on the wire used and how it is connected.

The wiring distance from the battery to the controller is 35 to 30 feet, depending on whether 14 AWG or 12AWG wires are used. 12 AWG will allow a distance of 20 feet. The length of the wire from the actuator to the controller can range from 25 feet to 10 feet. 12 AWG has a distance of 25 feet, while 14 AWG can only reach 10 feet in length. If the wire length exceeds the expected length, the actuator may not work properly. Product 8256-089 is designed for prime movers and can be installed near the engine. The ambient temperature of the actuator should not be higher than 200 degrees Fahrenheit. Model 8256-089 was discontinued by Woodward, but can be found via AX control. AX Control can repair, purchase and sell these products.

Woodward 8256-089 执行器 电动调速器

【其他型号推荐】