WOODWARD 5466-5001微网涡流探头速度传感器 四通道传感器
【产品详情】
5466-5001,微网涡流探头速度传感器是一种四通道传感器。该单元具有多个标准,ATEX,CSA和CE(EMC)。5466-5001 向后兼容,可与 5464-834 单元一起使用。
伍德沃德公司设计的5466-5001模块是一个速度传感器,特别是这个速度传感器被设计为涡流输入设备。该传感器的主要特点之一是没有电位计,因此在将模块插入所选机箱时不需要调整或校准。此模块可用于冗余或单工系统。由于该模块是涡流探头/输入设备,因此可用于检测极低的速度,因此带有涡流探头的模块可以检测到低至一赫兹的速度。
将 5466-5001 模块插入所选机箱后,它将滑入其中一个卡导轨并连接到机箱主板。无论设置了哪种软件配置,设备上的速度输入通道只有一个涡流证明可以接受。请注意,无论连接了哪个速度传感器输入通道,都必须在场转换模块(FTM)上跳线未使用的电涡流探头/ MPU。
5466-5001模块上可能发生一些潜在故障,要对设备进行故障排除,请验证以下一些内容;检查软件配置以确保输入配置正确,测量接线端子的输入电压 - 适当的电压应在三伏半到二十四伏的范围内。检查完这些模块或更换模块但问题尚未解决后,请更换FTM。
WOODWARD 5466-5001微网涡流探头速度传感器 四通道传感器
【英文介绍】
5466-5001, the micromesh eddy current probe speed sensor is a four-channel sensor. The unit has multiple standards, ATEX, CSA and CE (EMC). The 5466-5001 is backward compatible and can be used with the 5464-834 unit.
The 5466-5001 module designed by Woodward is a speed sensor, specifically the speed sensor is designed as a vortex input device. One of the main features of this sensor is that there is no potentiometer, so no adjustment or calibration is required when inserting the module into the selected case. This module can be used in redundant or simplex systems. Since the module is a vortex probe/input device, it can be used to detect extremely low speeds, so a module with a vortex probe can detect speeds as low as one Hertz.
After inserting the 5466-5001 module into the selected case, it slides into one of the card rails and connects to the case motherboard. No matter which software configuration is set, the speed input channel on the device has only one eddy proof acceptable. Please note that regardless of which speed sensor input channel is connected, an unused eddy current probe/MPU on the field conversion module (FTM) must be connected.
Some potential faults may occur on the 5466-5001 module. To troubleshoot the device, please verify the following; Check the software configuration to make sure the input configuration is correct and measure the input voltage to the terminal - the appropriate voltage should be in the range of three-and-a-half to twenty-four volts. After these modules are checked or replaced, replace the FTM.
WOODWARD 5466-5001微网涡流探头速度传感器 四通道传感器
【其他型号推荐】
PR6426/010-120 | EPRO | 前置器及传感器 | BENTLY 3309010050100200 | 压敏电阻板 | Bently Nevada |
PR6426/010-110 | EPRO | 前置器及传感器 | BENTLY 3309010018100200 | 检测模块 | Bently Nevada |
PR6426/010-100 | EPRO | 前置器及传感器 | BENTLY 330900-50-05 | 伺服定位系统 | Bently Nevada |
PR6426/010-040 | EPRO | 前置器及传感器 | BENTLY 330900-50-00 | TR控制板 | Bently Nevada |
PR6426/010-030 | EPRO | 前置器及传感器 | BENTLY 3308812808098060 | SOE主模件 | Bently Nevada |
PR6426/010-020 | EPRO | 前置器及传感器 | BENTLY 3308812800165070 | 环路数据处理模件 | Bently Nevada |
PR6426/010-010 | EPRO | 前置器及传感器 | BENTLY 330878-90-00 | 计算机接口模件 | Bently Nevada |
PR6426/010-000 | EPRO | 前置器及传感器 | BENTLY 330877803700 | DCS板 | Bently Nevada |
PR6426/000-141 | EPRO | 前置器及传感器 | BENTLY 33087601100100 | 可编程控制系统 | Bently Nevada |
PR6426/000-140 | EPRO | 前置器及传感器 | BENTLY 330854-080-24-05 | ABBIGBT模块 | Bently Nevada |
PR6426/000-130 | EPRO | 前置器及传感器 | BENTLY 3308510500271000 | 模件总线电缆适配器接口 | Bently Nevada |
PR6426/000-121 | EPRO | 前置器及传感器 | BENTLY 330851-04-000-023-10-01-05 | 模件总线连接电缆 | Bently Nevada |
PR6426/000-111 | EPRO | 前置器及传感器 | BENTLY 330851-02-000-070-50-00-05 | 诊断电缆 | Bently Nevada |
PR6426/000-101 | EPRO | 前置器及传感器 | BENTLY 330850-90-05 | 按键屏 | Bently Nevada |
PR6426/000-100 | EPRO | 前置器及传感器 | BENTLY 330850-90-00 | 红外通讯 | Bently Nevada |
PR6426/000-041 | EPRO | 前置器及传感器 | BENTLY 330850-51-05 | S型热电偶 | Bently Nevada |
PR6426/000-031 | EPRO | 前置器及传感器 | BENTLY 330850-50-CN | 端口号 | Bently Nevada |