WOODWARD 9907-014 电子负载分配

【产品详情】

伍德沃德零件 9907-014 系列 2301A 负载分配和速度控制。具体来说，速度控制模型，1.0 V的起动速度不超过30 Vrms。

产品编号 9907-014 是伍德沃德 2301A 系列负载分配和速度控制的一部分。9907-014 型号在低压标度上运行，工作电源位于 20-40 Vdc。 该型号专门设计为速度控制系统，而不是负载分配和速度控制系统。

使用控制器和使用磁性拾音传感器时，您需要测量电压，通过测量第 1 个和第 0 个端子来实现。当控制处于起动速度时，端子上的最低电压将为 30.30 V，在额定速度下，Vrms 应为 1，如果由于任何原因电压超过 0 V，则需要增加速度传感器的间隙，在执行这些操作时确保起动速度下的 V 仍位于 <>.<>。

所有用于将控制连接到发动机的电缆都必须屏蔽，这些电缆必须是双绞线对。在任何情况下，您都不应尝试焊接编织屏蔽层。否则可能会导致严重伤害和电缆故障。连接控制器时必须正确接地，将从接地连接到接地接线片，以便为控制器的机箱提供真正的接地。

WOODWARD 9907-014 电子负载分配

【英文介绍】

Woodward Part 9907-014 Series 2301A Load Distribution and speed control. Specifically, the speed control model, 1.0V starting speed does not exceed 30 Vrms.

Product number 9907-014 is part of the Woodward 2301A series load Distribution and speed control. Models 9907-014 operate on a low voltage scale with an operating power supply located at 20-40 Vdc. This model is specifically designed as a speed control system rather than a load distribution and speed control system.

When using a controller and when using a magnetic pickup sensor, you need to measure the voltage, by measuring the 1st and 0th terminals. When the control is at the starting speed, the minimum voltage on the terminal will be 30.30 V, at the rated speed, the Vrms should be 1, if for any reason the voltage exceeds 0 V, it is necessary to increase the gap of the speed sensor, while performing these operations to ensure that the V at the starting speed is still at <>.<>.

All cables used to connect the controls to the engine must be shielded, and these cables must be twisted pairs. Under no circumstances should you attempt to weld braided shields. Failure to do so may result in serious injury and cable failure. The controller must be properly grounded when connected, from the ground to the ground strip in order to provide true grounding to the controller's case.

WOODWARD 9907-014 电子负载分配

【其他型号推荐】