9905-145 带有控制装置 2301-9905 WOODWARD

【产品详情】

伍德沃德零件 9905-145 系列 2301A 负载分配和速度控制。6 A CT 电流下最大负载增益为 5 Vdc，MPU 间隙为 0.010-0.040 英寸

带有控制装置 2301-9905 的 Woodward 145A 负载分配和速度控制系列 9905-145 有高压或低压型号，如果您购买的型号是高压型号，它将在控制器的钣金框架的正面指示，而如果是低压型号，则不会在控制器的正面指示。请注意，型号的电源额定值不同，高压型号可以在 88-132 的 Vac 范围内运行，而低压型号则不能与 Vac 电源一起使用。

评估所有端子、螺钉和钣金框架，以确保没有损坏，其中任何损坏都会阻碍控制器的功能，并且在使用发动机操作时可能会导致故障。电位计在收到控件时不会设置，必须由操作员设置。

在评估和打开控制包装时，请检查速度传感器是否损坏，如果传感器是MPU（磁性拾音器），请确保传感器和齿轮之间有适当的间隙，两者之间的间隙应为 0.010 至 0.040 英寸。

9905-145 带有控制装置 2301-9905 WOODWARD

【英文介绍】

Woodward Part 9905-145 Series 2301A Load Distribution and speed control. The 6 A CT has a maximum load gain of 5 Vdc at current and an MPU gap of 0.010 to 0.040 inches

The Woodward 145A load distribution and Speed Control series with control unit 2301-9905 is available for sale at AX Control, which we also purchase, repair and refurbish. The 9905-145 is available in high pressure or low pressure models, if the model you purchase is a high pressure model, it will be indicated on the front of the sheet metal frame of the controller, while if it is a low pressure model, it will not be indicated on the front of the controller. Please note that the power supply ratings of the models differ, the high voltage models can operate in the 88-132 Vac range, while the low voltage models cannot be used with the Vac power supply.

Evaluate all terminals, screws, and sheet metal frames to ensure that there is no damage, any of which will hinder the function of the controller and may cause failure when operating with the engine. The potentiometer is not set when the control is received and must be set by the operator.

When evaluating and opening the control package, check the speed sensor for damage, and if the sensor is an MPU (magnetic pickup), make sure there is a proper clearance between the sensor and the gear, the gap between the two should be 0.010 to 0.040 inches.

9905-145 带有控制装置 2301-9905 WOODWARD

【其他型号推荐】