9905-135 尾轴调速器 WOODWARD

【产品详情】

伍德沃德型号 9905-134 系列 2301A 负载分配和速度控制。0-500 ms 的时间连续兼容性，CSA 认证，具有可选的速度控制范围。

此特定型号专为伍德沃德的 2301A 负载分配和速度控制系统而设计。当使用控制线上的执行器输出时，它是到发动机调速器的端子九，连接两个调速器将电线从发动机调速器的端子十连接到尾轴调速器上的端子十二。

与控制器的执行器电压有关，如果在最小设置下缓慢开始顺时针转动额定速度电位器，如果使用反向作用控制，则逆时针转动电位器，直到电压勉强开始稳定攀升。如果由于任何原因在操作时原动机以降低的速率搜寻，则开始增加复位电位计，直到它开始稳定，如果这种方法不能解决问题并稳定原动机，则考虑通过缓慢降低或降低增益电位器以及同时增加执行器补偿来评估增益电位器。在操作控制时，执行器补偿应以0-500 ms的时间连续兼容性读取。

9905-135 尾轴调速器 WOODWARD

【英文介绍】

Woodward Model 9905-134 Series 2301A Load Distribution and speed control. 0-500 ms time continuous compatibility, CSA certified, with optional speed control range.

This particular model is designed for Woodward's 2301A load distribution and speed control system. When using the actuator output on the control line, which is to terminal nine of the engine governor, connect the two governors to connect the wire from terminal ten of the engine governor to terminal twelve on the tailshaft governor.

In relation to the actuator voltage of the controller, if the rated speed potentiometer is slowly started to turn clockwise at the minimum setting, if the reverse action control is used, the potentiometer is turned counterclockwise until the voltage barely begins to climb steadily. If for any reason the prime mover is searching at a reduced rate while operating, start increasing the reset potentiometer until it begins to stabilize, if this method does not solve the problem and stabilize the prime mover, consider evaluating the gain potentiometer by slowly lowering or lowering the gain potentiometer and simultaneously increasing the actuator compensation. At the time of operation control, the actuator compensation should be read with time continuous compatibility of 0-500 ms.

9905-135 尾轴调速器 WOODWARD

【其他型号推荐】