9905-038  负载分配和速度控制 调整电位器

【产品详情】

伍德沃德零件 9905-038 系列 2301A 负载分配和速度控制。该型号提供减速斜坡，负载分配为 0-6 VDC。这种模式是前瞻性的。

如果您正在寻找伍德沃德系列 2301A 负载分配和速度控制型号 9905-038 。如果需要对预设额定速度进行任何调整，请根据需要调整电位器，如果信号发生器未与您的控制器一起使用，请将电位计转到绝对最小设置;如果使用信号发生器在控件上设置额定速度，请将发生器设置为速度传感器的频率为额定速度的频率。

当转动控制器上的任何电位器时，应该注意，唯一作为多圈运行的电位器是额定速度电位器，此控件上的所有其他电位器都是单圈的，因此转动单圈电位器时需要小心，如果它们超过停止，可能会导致控件无法正常工作。

9905-038  负载分配和速度控制 调整电位器

【英文介绍】

Woodward Part 9905-038 Series 2301A Load Distribution and speed control. This model offers deceleration ramps with load distribution of 0-6 VDC. This model is forward-looking.

If you are looking for Woodward Series 2301A Load Distribution and Speed Control Model 9905-038 AX Control for you buy, sell, repair and refurbish this model. If any adjustment to the preset speed rating is required, adjust the potentiometer as needed, or if the signal generator is not being used with your controller, turn the potentiometer to the absolute minimum setting; If you use a signal generator to set the rated speed on the control, set the generator to the frequency of the rated speed for the speed sensor.

When turning any potentiometer on the controller, it should be noted that the only potentiometer that operates as a multi-turn is the rated speed potentiometer, all other potentiometers on this control are single-turn, so care needs to be taken when turning the single-turn potentiometer, if they exceed the stop, it may cause the control to not work properly.

9905-038  负载分配和速度控制 调整电位器

【其他型号推荐】