9905-036 具有单个执行器 电位计是可调的

【产品详情】

9905-036 模块是高压正向作用 2301A 电子负载分配和速度控制之一。模块上的执行器电流为0-20 mA，具有单个执行器，并且没有减速斜坡。

Woodward Incs 的负载共享和速度控制型号 9905-036 2301A 系列是高压型号正向作用型号;9905-036 型号由单个执行器组成，在 0-20 mA 的执行器电流上运行。该模型用于许多原动机，从柴油、汽油或天然气发动机到蒸汽和燃气轮机。调速的目的是自动调整原动机的启动燃油限制;这样做可以在发动机或涡轮机开始时调节最大燃料，以帮助减少发动机/涡轮机的磨损以及污染。

9905-036 型号在机箱前部配有电位计;电位计是可调的，可以更改为用户所需的设置，以确保连接的原动机充分发挥其潜力。9905-036 控制器上的电位器之一是速度;速度电位器可以根据速度传感器频率（以赫兹 （Hz） 为单位）进行设置。控制器的速度范围设置在内部拨码开关上，如果需要更改速度范围，可以在盖子内访问。可以将外部额定速度调节连接到该控制器以远程更改速度。

如果您希望在 9905-036 上运行怠速或额定斜坡触点，请使用连接到发动机调速器上五端子的单极触点单掷开关，打开怠速触点，然后关闭额定触点，通常来自发动机油的压力将关闭端子。当控制器的触点打开时，来自五端子的电压被停用，发动机的速度开始减速到怠速位置。

9905-036 具有单个执行器 电位计是可调的

【英文介绍】

The 9905-036 module is one of the high voltage forward acting 2301A electronic load distribution and speed control. The actuator current on the module is 0-20 mA, with a single actuator and no deceleration ramp.

Woodward Incs load sharing and speed control model 9905-036 2301A series is a high voltage forward acting model; The 9905-036 model consists of a single actuator and operates on an actuator current of 0-20 mA. The model is used in many prime movers, from diesel, gasoline or natural gas engines to steam and gas turbines. The purpose of speed regulation is to automatically adjust the starting fuel limit of the prime mover; Doing so adjusts the maximum fuel at the start of the engine or turbine to help reduce engine/turbine wear as well as pollution.

Models 9905-036 have a potentiometer at the front of the case; The potentiometer is adjustable and can be changed to the Settings required by the user to ensure that the connected prime mover reaches its full potential. One of the potentiometers on the 9905-036 controller is speed; The speed potentiometer can be set according to the speed sensor frequency in Hertz (Hz). The speed range of the controller is set on the internal dip switch, and if you need to change the speed range, it can be accessed inside the cover. An external rated speed adjustment can be connected to this controller to change the speed remotely.

If you wish to run idle or rated ramp contacts on the 9905-036, use the single-pole contact single-throw switch connected to the five terminals on the engine governor, open the idle contacts, then close the rated contacts, usually the pressure from the engine oil will close the terminals. When the controller's contacts are opened, the voltage from the five terminals is deactivated and the engine's speed begins to slow down to the idle position.

9905-036 具有单个执行器 电位计是可调的

【其他型号推荐】