TRICONEX 3625C1脉冲输入模块

【产品详情】

TRICONEX3625C1产品参数

输入电压:24VDC

输出功率:15W

工作温度:-40℃至85℃

防护等级:IP67

支持通讯协议:Modbus RTU

尺寸:120mm x 80mm x 40mm

重量:500g

外壳材料:铝合金

安装方式:DIN

请先确认输入电压符合要求再进行接线

避免长时间在高温环境下使用

请勿在潮湿的环境下使用

(1)带保护输出型:具有电子保护,能够在短路、过载或过热情况下切断输出,在输出故排除时自动恢复，没有故状态信息提供给处理器模块型号末尾为P

(2)带电子保险型:能够在故障发生时断开输出,通过操作按钮、软件或输入重新通电复位"保险”。故状态信息提供给处理器,模块型号末尾为EP。

3)带自诊断型能够检测、指示并报告给处理器如下故现场输入或输出设备开路或接线开路:现场设备输出短路,输入或输出接线短路用户电源接结反极性，模块

型号末尾为D。

(4)隔离型:内部I/O通道间相互隔离,模块型号末尾为1.

TRICONEX3625C1故障保护系统的tory特性，必须及时检测所有故障，并在检测到输入故障时，强制测量的输入值处于安全状态。由于Tricon针对断电跳闸应用程序进行了优化，因此检测到输入电路中的故障会强制关闭（断电状态）每个通道向主处理器报告的值。数字输出模块有四种基本类型的数字输出模块：双输出、监控输出、直流电压输出和交流电压输出。以下输入Mux总线Xcvr阈值检测程序光电隔离器-+A输入Mux母线Xcvr-Proc-+B输入Mux汇流条Xcvr/Proc-+C单个点场终端桥接整流器光电隔离AC/DC输入电路单个光电隔离智能I/O控制器交流平滑阈值检测光电隔离者阈值检测光电隔离器腿对腿隔离控制信号智能输入/输出控制器三许可输入/输出总线现场电路典型点（32个中的一个）双端口RAM双端口RAM双口RAM光隔离器带自检（DC模型）总线Xcvr过程点寄存器总线Xcv过程点寄存器母线XcvrProc点寄存器输出开关驱动电路A A和B输出开关驱动线路输出开关驱动电路B输出开关驱动回路C A B C A和B A A B C C+V A B C三重I/O总线现场电路典型点（16）环回检测器LD RTN智能I/O控制器*****所有输出开关都是光隔离的。从其他点到其他点，16点监控数字输出模块7的环回检测器架构段落描述了数字输出模块的一般情况，然后是四种类型的细节。每个数字输出模块包含三个相同、隔离通道的电路。每个通道包括一个I/O微处理器，该微处理器从相应主处理器上的I/O通信处理器接收其输出表。

TRICONEX 3625C1脉冲输入模块

TRICONEX 3625C1 Product specifications

Input voltage :24VDC

Output power :15W

Operating temperature :-40℃ to 85℃

Protection level :IP67

Supported communication protocol :Modbus RTU

Size :120mm x 80mm x 40mm

Weight :500g

Shell material: Aluminum alloy

Installation mode :DIN

Ensure that the input voltage meets the requirements before connecting cables

Avoid prolonged use in high temperature environments

Do not use in humid environment

(1) With protection output type: with electronic protection, it can cut off the output in the case of short circuit, overload or overheating, and automatically recover when the output is excluded, and no state information is provided to the processor module model at the end of P

(2) With electronic insurance type: can disconnect the output when the fault occurs, and reset the "insurance" by operating the button, software or input. Therefore, the status information is provided to the processor. The end of the module model is EP.

3) With self-diagnostic type can detect, indicate and report to the processor as follows: field input or output device open circuit or wiring open circuit: field device output short circuit, input or output wiring short circuit User power junction reverse polarity, module

The end of the model is D.

(4) Isolation type: The internal I/O channels are isolated from each other, and the end of the module model is 1.

TRICONEX 3625C1 The tory feature of the TriconeX 3625C1 fault protection system must detect all faults in a timely manner and force the measured input value to be in a safe state when an input fault is detected. Because Tricon is optimized for power-off trip applications, detecting a fault in the input circuit forces a shutdown (power-off state) of the value each channel reports to the main processor. There are four basic types of digital output modules: dual output, monitor output, DC voltage output and AC voltage output. The following input Mux bus Xcvr threshold detection program Optical isolator -+A input Mux bus XCVR-PROC- +B input Mux bus Xcvr/Proc-+C Single point field terminal bridge rectifier Optical isolation AC/DC input circuit Single optical isolation Intelligent I/O controller AC smoothing threshold detection Optical isolator threshold detection Metering electrical isolator leg-to-leg isolation control signal Intelligent input/Output controller three license input/output bus field circuit Typical point (one of 32) Dual port RAM Dual port RAM Dual port RAM Optical isolator with self-check (DC model) bus Xcvr process point register bus Xcv Process point register bus XcvrProc point register output Switch driver circuit A A and B Output switch Driver Line Output switch Driver circuit B Output switch driver circuit C A B C A and B A A B C C+V A B C Triple I/O bus field circuit Typical point (16) Loopback detector LD RTN Intelligent I/O controller ***** All output switches are optically isolated. From other points to other points, the loopback detector architecture of the 16-point monitoring digital output Module 7 describes the general situation of the digital output module, followed by four types of details. Each digital output module contains three identical, isolated channels of circuitry. Each channel includes an I/O microprocessor that receives its output table from the I/O communication processor on the corresponding main processor.

TRICONEX 3625C1脉冲输入模块

【下单请联系我们】

欢迎访问厦门雄霸

销售经理：何小姐

电子邮件ID：2082431634 qq.com

微信：18059868280

手机：+86 18059868280

在线客服qq：2082431634

地址：厦门市思明区吕岭路1733号创想中心2009室

（1）24小时电子邮件回复（12小时）;

（2）对于运往亚洲以外的国家/地区，请联系卖方。

【常见问题】

无论您对库存，价格，故障排除还是其他方面有任何疑问，我们都能满足您的需求。请致电我们，填写我们的表格，或向我们发送电子邮件-任何适合您的方式。期待您的回音！

问：您的交货时间如何？

答：我们有很多库存商品，3-5天您将收到它。

问：你们提供保修吗？

答：是的，我们为所有剩余的部件提供1年保修。

问：您可以接受哪些付款方式？

答：通常我们在中国大陆接受T/T和人民币转账