IS220PAICH1A 模拟 I/O 包 描述为 I/O 端口

【产品详情】

该IS220PAICH1A型号被描述为模拟 I/O 包，已获准用于危险和非危险场所。在模型的正面，有四个指标。底部还有一个端口，被描述为 I/O 端口。PAIC电池组可以使用多种电压，PAIC电池组的最小电压为27点4伏直流电。

由于 IS220PAICH1A 套件能够在许多地点使用，因此获得了各种认证，其中一些是危险场所、一区二组 IIC、一类二区 A、B、C、D 组和 ATEX 二区、IIC 组和非危险场所。以下认证用于地点，UL E207685 和 UL DEMKO 12 ATEX 1114875X，请注意 UL E207685 认证在许多地点使用。

IS220PAICH1A单元可以使用三种型号，即IS200STAIH1A和IS200STAIH2A以及IS20TBAIH1C型号。所有这些型号都被称为输入输出端子板。

PAIC I/O 包的典型位置将位于两个可用 VME 机架之一中，即 13 或 21 个插槽机架。 请注意，该装置通常与三重模块化冗余架构系统一起使用。TMR 系统有一个单独的控制模块、I/O 网络和主处理器卡。

IS220PAICH1A 模拟 I/O 包 描述为 I/O 端口

【英文介绍】

The IS220PAICH1A model is described as an analog I/O package that has been approved for use in hazardous and non-hazardous locations. On the front side of the model, there are four indicators. There is also a port on the bottom, which is described as an I/O port. The PAIC battery pack can use a variety of voltages, the minimum voltage of the PAIC battery pack is 27.4 volts DC.

Because the IS220PAICH1A kit is capable of being used in many locations, various certifications have been obtained, some of which are Hazardous Sites, Zone 1 Group 2 Iics, Zone 1 Group 2 A, B, C, D and ATEX Zone 2, IIC Group and non-hazardous Sites. The following certifications are used in locations, UL E207685 and UL DEMKO 12 ATEX 1114875X, please note that UL E207685 certifications are used in many locations.

The IS220PAICH1A unit can be used in three models, namely the IS200STAIH1A and IS200STAIH2A, and the IS20TBAIH1C model. All of these models are referred to as input/output terminals.

The typical location for a PAIC I/O package will be in one of the two available VME racks, i.e. 13 or 21 slot racks. Note that this device is often used with triple modular redundant architecture systems. The TMR system has a separate control module, I/O network, and main processor card.

IS220PAICH1A 模拟 I/O 包 描述为 I/O 端口

【其他型号推荐】