GE IC695ACC412 替换盖组 电源在能量组中保持
【产品详情】
IC695ACC412盖组是GE Fanuc制造的用于能量组的替换盖组。它是RX3i能量包的升级或更换模块。能量包专门用于在断电和故障期间保存用户内存。它与GE CPE330 CPU一起使用。电源在能量组中保持,它可以保持足够长的电源,以便CPU将其内容写入非易失性存储器。盖组配有使用寿命为 5 年的电容器。IC695ACC412盖组安装在能量组的底部。在能量组中安装盖组期间,应完全断开电源。在安装过程中,所有 LED 都应关闭。
在更换IC695ACC412盖组期间,应停止电源循环,直到新盖组充满容量并完全正常工作。应卸下位于能量组底部的 4 个螺钉,以从底座中取出IC695ACC412帽组。然后,可以将新电池组与模块连接到底座连接器,并在底座上推入到位。螺钉不应拧得太紧,因为这可能会损坏外壳。安装盖组后,能量组中的“STAT”LED 呈绿色亮起,直到电池组充满电。在此期间,不应卸下能量组的电源。IC695ACC412盖组在不使用时应存放在无尘环境中,没有任何EMC噪音。
GE IC695ACC412 替换盖组 电源在能量组中保持
【英文介绍】
The IC695ACC412 cover set is a replacement cover set manufactured by GE Fanuc for energy sets. It is an upgrade or replacement module for the RX3i energy pack. The power pack is specifically designed to preserve user memory during power outages and failures. It is used with the GE CPE330 CPU. The power supply is held in the energy group, which can hold the power supply long enough for the CPU to write its contents to non-volatile memory. The cover is equipped with a capacitor with a service life of 5 years. The IC695ACC412 cover group is installed at the bottom of the energy group. The power supply should be completely disconnected during the installation of the cover pack in the energy pack. All leds should be turned off during installation.
During the replacement of the IC695ACC412 cover group, the power cycle should be stopped until the new cover group is full of capacity and fully functioning. The 4 screws located at the bottom of the energy pack should be removed to remove the IC695ACC412 cap pack from the base. The new battery pack and module can then be connected to the base connector and pushed into place on the base. The screws should not be tightened too tightly, as this may damage the housing. After the cover pack is installed, the "STAT" LED in the energy pack lights up green until the battery pack is fully charged. During this time, the power supply to the energy group should not be removed. The IC695ACC412 cover group shall be stored in a dust-free environment without any EMC noise when not in use.
GE IC695ACC412 替换盖组 电源在能量组中保持
【其他型号推荐】
PR9268/205-000 | EPRO | 前置器及传感器 | BENTLY 330703-000-050-10-02-00 | 数字输出模块 | Bently Nevada |
PR9268/203-100 | EPRO | 前置器及传感器 | BENTLY 3307030000405010 | DCS控制器 | Bently Nevada |
PR9268/203-000 | EPRO | 前置器及传感器 | BENTLY 330703-000-040-10-11-00 | 杜比数字影院音频处理器 | Bently Nevada |
PR9268/202-000 | EPRO | 前置器及传感器 | BENTLY 330703-000-040-10-02-05 | 触摸屏模块 | Bently Nevada |
PR9268/202-000 | EPRO | 前置器及传感器 | BENTLY 3307020030100200 | 可编程逻辑控制器 | Bently Nevada |
PR9268/201-110 | EPRO | 前置器及传感器 | BENTLY 3307010025100200 | 禹力模块 | Bently Nevada |
PR9268/201-100 | EPRO | 前置器及传感器 | BENTLY 330550-A06-B00 | 伺服系统 | Bently Nevada |
PR9268/201-000 | EPRO | 前置器及传感器 | BENTLY 33052502 | 接口模板 | Bently Nevada |