531X171TMAAEG2 大多数信号I / O的连接端子

【产品详情】

GE端子板继电器卡531X171TMAAEG2包含接口电路和大多数信号I / O的连接端子。该板通过电缆连接到驱动器控制板。

GE 端子板继电器卡 531X171TMAAEG2 具有多个连接器，用于将电路板连接到驱动器中的组件的电缆。在开始更换之前，请检查有缺陷的电路板并记下连接到它的所有电线和电缆。该板具有一个端子，其上连接了多根单线，用于将电信号发送到驱动器中的其他组件。它还提供发送到电路板进行处理的信号。创建标签，提供有关端子上电线连接位置的信息。这将避免更换板接线不正确的可能性，从而导致驱动器进一步停机。

要从端子上取下电线，请创建标签并将其应用于电线。每个端子都有一个单独的连接器，用螺钉固定到位。使用螺丝刀松开将电线固定到位的螺钉。从端子上取下电线，并在驱动器中安装新板时将其移动到一侧。要将电线安装在新板中，请使用螺丝刀松开螺钉并将电线插入连接器中。确保裸机在连接器中。用螺丝刀拧紧接头。

531X171TMAAEG2 大多数信号I / O的连接端子

【英文介绍】

GE terminal board Relay card 531X171TMAAEG2 contains interface circuits and connection terminals for most signal I/OS. The board is connected to the driver control board by cable.

GE Terminal board Relay Card 531X171TMAAEG2 has multiple connectors for connecting the circuit board to the cables of the components in the driver. Before starting the replacement, check the defective circuit board and make note of all the wires and cables connected to it. The board has a terminal on which multiple single wires are connected for sending electrical signals to other components in the driver. It also provides a signal that is sent to the board for processing. Create labels that provide information about where the wires are connected on the terminals. This will avoid the possibility of incorrect wiring of the replacement board, leading to further driver downtime.

To remove the wire from the terminal, create a label and apply it to the wire. Each terminal has a separate connector that is secured in place with screws. Use a screwdriver to loosen the screws holding the wires in place. Remove the wire from the terminal and move it to the side when installing the new board in the driver. To install the wire in the new board, use a screwdriver to loosen the screw and insert the wire into the connector. Make sure the bare device is in the connector. Tighten the connector with a screwdriver.

531X171TMAAEG2 大多数信号I / O的连接端子

【其他型号推荐】