531X171TMAABG2 包含接口电路和大多数信号I / O的连接端子
【产品详情】
GE端子板继电器卡531X171TMAABG2包含接口电路和大多数信号I / O的连接端子。 该板通过电缆连接到驱动器控制板。GE端子板继电器卡531X171TMAABG2包含一个接线端子,在尝试将电线连接到它之前,需要考虑该接线端子。接线端子用于固定用于发送和接收控制信号的单根电线。每根电线都用小螺丝固定在接线端子上。
要将电线连接到接线端子,请用螺丝刀松开螺钉,但不要卸下螺钉。将电线插入端子,并确保它完全啮合在连接器中。使用螺丝刀拧紧螺钉并将电线固定在接线端子中。拉动电线以测试连接。
GE端子板继电器卡531X171TMAABG2用四个螺钉固定在驱动柜内。首先,断开驱动器的所有电源,然后等待几秒钟,让主板上的所有电源耗尽。电路板的某些组件在断电后保持电压几秒钟,因此为了避免人身伤害,留出时间让所有电源耗尽非常重要。
松开四个螺钉以卸下有缺陷的主板。但是,请确保螺丝刀没有接触驱动器内的任何组件。在卸下连接到主板的任何电缆之前,请记下它们的连接位置,并使用连接器的标识符标记每根电缆。
531X171TMAABG2 包含接口电路和大多数信号I / O的连接端子
【英文介绍】
GE terminal board Relay card 531X171TMAABG2 contains the interface circuit and most of the signal I/O connection terminals. The board is connected to the driver control board by cable. The GE terminal board relay card 531X171TMAABG2 contains a terminal that needs to be considered before attempting to connect a wire to it. Terminals are used to secure a single wire for sending and receiving control signals. Each wire is secured to the terminal with a small screw.
To connect the wire to the terminal, loosen the screw with a screwdriver, but do not remove the screw. Insert the wire into the terminal and make sure it is fully engaged in the connector. Use a screwdriver to tighten the screw and secure the wire in the terminal. Pull the wire to test the connection.
The GE terminal board relay card 531X171TMAABG2 is secured in the drive cabinet with four screws. First, disconnect all power to the drive, then wait a few seconds for all power on the motherboard to run out. Some components of the board maintain voltage for a few seconds after a power outage, so it is important to allow time for all power to run out in order to avoid personal injury.
Loosen the four screws to remove the defective motherboard. However, make sure that the screwdriver is not touching any components inside the drive. Before removing any cables connected to the motherboard, make a note of where they are connected and mark each cable with the connector's identifier.
531X171TMAABG2 包含接口电路和大多数信号I / O的连接端子
【其他型号推荐】
ICS TRIPLEX | T8111C | TERASAKI | ERC-244 | GE | Hydran M2 |
ICS TRIPLEX | T8850 | ABB | HIEE200038R0001 | A-B | 2098-DSD-020X/C |
FOXBORO | FCP270 P0917YZ | FOXBORO | FBM214B P0927AH | BENTLY | 128229-01 |
ABB | PM866 3BSE050200R1 | HONEYWELL | 05701-A-0302 | BENTLY | 128229-01 |
ABB | 07DC92D GJR5252200R0101 | WOODWARD | 9907-1290 | BLACK BOX | ACR1000A-R2 |
ABB | LDGRB-01 3BSE013177R1 | DANFOSE | EKC 361 | TRICONEX | 3504E |
GE | DS200VPBLG1A | ABB | MB510 3BSE002540R1 | ABB | 3BDH000741R1 |
GE | DS200DDTBG1A | ABB | DAPI100 3AST000929R109 | HONEYWELL | TK-CCR014 |
GE | DS200FCGDH1 B | ABB | CI522A 3BSE018283R1 | WOODHEAD | DRL-DPM-BKF |
YOKOGAWA | SAI143-H53 | SCANLAB | INTELLISCANDE III14-532NM SCANLAB | Rolls-Royce | SLIO 02 |
SEM | MT30R4-37 | BENTLY | 3500/22M 138607-02 | ABB | 3BDH000741R1 |
ABB | UFC789AE101 | ENTERASYS | A4H1 24-24TX P0973JM | HONEYWELL | TK-CCR014 |
KONGSBERG | RMP201-8 | ENTERASYS | STK-RPS-1 50PS P0973BP | WOODHEAD | DRL-DPM-BKF |
HONEYWELL | R7247C1001 | ENTERASYS | A2H124-24FX P0973BJ | Rolls-Royce | SLIO 02 |
GE | VMIVME-7750 VMIVME-7 750-746001350-027750-746001 P | ENTERASYS | A2H254-16 P0973BK | WOODWARD | 9905-973 |
GE | VMIVME-7750 VMIVME-7 750-734001350-027750-734001 K | ENTERASYS | C2G170-24 P0973BL | A-B | 2711P-B6C20D |
GE | VMIVME-7750 VMIVME-7 750-746001350-027750-746001 P | ENTERASYS | A4H254- -8F8T P0973JP | PROSOFT | MVI56-BAS |
GE | VMIVME-7750 | ENTERASYS | A4H124-24FX PO973JN | ABB | 3BUS208800-001 |
TRICONEX | 9566-8XX | ICS TRIPLEX | T8111C | HONEYWELL | FC-SDO-0824 V1.3 |
ABB | REF620E_F NBFNAAAANDA1BNN1XF | ICS TRIPLEX | T8850 | BENTLY | 128229-01 |
GE | IS420UCSBH4A | FOXBORO | FCP270 P0917YZ | BLACK BOX | ACR1000A-R2 |
ABB | 5SHY3545L0016 3BHB020720R0002 3BHE019719R0101 GVC736BE101 | TRICONEX | 3504E |