531X171TMAABG1 包含接口电路和连接端子

【产品详情】

GE端子板继电器卡531X171TMAABG1包含接口电路和连接端子，用于大多数信号I / O。该板通过电缆连接到驱动器控制板。GE 终端板继电器卡 531X171TMAABG1 具有 RS232C 串行端口连接，可用于将主板连接到笔记本电脑或其他设备。

要使用连接，必须确保笔记本电脑上的每个端口都分配有一个唯一的地址。要配置串行端口，请访问安装配置实用程序并分配地址，并确保端口未被禁用。您还可以确保设备兼容。您还可以确保串行连接器连接到笔记本电脑上的正确连接器。串行连接可用作驱动器配置工具和诊断工具的接口。

该板包含跳线和 DIP 开关，使安装人员能够配置用于驱动器的板。在安装更换板之前，请小心地找到有缺陷的板上的跳线和 DIP 开关，并在更换板上设置跳线和 DIP 开关以匹配有缺陷的板。您可能会发现跳线和开关的位置已在新板上更新。即使位置可能已更改，也可以在新板上找到跳线标识符并将跳线设置为相同位置。

531X171TMAABG1 包含接口电路和连接端子

【英文介绍】

GE terminal board relay card 531X171TMAABG1 contains interface circuits and connection terminals for most signal I/O. The board is connected to the driver control board by cable. GE Terminal board Relay card 531X171TMAABG1 has RS232C serial port connection and can be used to connect the motherboard to a laptop or other device.

To use the connection, you must ensure that each port on your laptop is assigned a unique address. To configure the serial port, access the installation Configuration utility and assign an address, and make sure the port is not disabled. You can also ensure that your devices are compatible. You can also make sure that the serial connector is connected to the correct connector on your laptop. The serial connection can be used as an interface for drive configuration tools and diagnostic tools.

The board contains jumpers and DIP switches that enable the installer to configure the board for the drive. Before installing the replacement board, carefully locate the jumper and DIP switch on the defective board and set the jumper and DIP switch on the replacement board to match the defective board. You may find that the position of the jumper and switch has been updated on the new board. Even though the location may have changed, you can find the jumper identifier on the new board and set the jumper to the same location.

531X171TMAABG1 包含接口电路和连接端子

【其他型号推荐】