DS200SDCIG2AEB  GE直流电源和仪表板

【产品详情】

GE直流电源和仪表板DS200SDCIG2AEB作为DC2000驱动器的接口。DS200SDCIG2AEB是一种静电敏感器件，在触摸、维护和安装设备时必须小心。静电会通过空气、接触设备的人员、接触其他设备和结构等途径积聚在单板上。静电会损坏单板上的敏感元器件，导致单板无法使用。

如果需要对单板进行维护，请将单板放在平整干净的表面上，并在接触单板之前佩戴好接地带。接地带可以防止静电积聚。

走路和触摸物品会导致静电积聚，所以在使用电路板之前最好不要移动太多。当你做处理板只持有它的边缘，永远不要触摸焊点或组件。在准备安装之前，将其从包装中取出，触摸未涂漆的金属表面，以排出任何静电。只有这样，才可以安全安装更换后的单板。

如果单板从包装袋中取出后必须放下，请将单板放在空的防静电包装袋上。

DS200SDCIG2AEB上的电容器即使在断开电流后也能存储高压电流，因此在触摸电路板之前测试电路板的电流是很重要的，以防止电烧伤和触电。

DS200SDCIG2AEB  GE直流电源和仪表板

【英文介绍】

The GE DC power supply and the dashboard DS200SDCIG2AEB serve as the interface for the DC2000 driver. The DS200SDCIG2AEB is an electrostatic sensitive device, and care must be taken when touching, maintaining, and installing the device. Static electricity accumulates on boards through the air, people touching the devices, and other devices and structures. Static electricity may damage the sensitive components on the board, and the board cannot be used.

If you need to maintain the board, place the board on a flat and clean surface, and wear the ground strap before touching the board. The ground zone prevents static electricity from accumulating.

Walking and touching objects can cause static electricity to build up, so it's best not to move too much before using the board. When you do handle the board only hold its edges and never touch the solder joints or components. Before preparing for installation, remove it from its packaging and touch the unpainted metal surface to expel any static electricity. In this way, you can safely install the new board.

If you need to lay down the board after taking it out of the bag, place the board in an empty ESD bag.

The capacitors on the DS200SDCIG2AEB can store high-voltage current even after disconnecting the current, so it is important to test the circuit board's current before touching it to prevent electrical burns and shock.

【其他型号推荐】

DS200SDCIG2AEB  GE直流电源和仪表板