IC693BEM335 可编程逻辑控制器 以太网网络接口模块

【产品详情】

GE Fanuc IC693BEM335以太网网络接口模块适用于90-30系列可编程逻辑控制器(plc)，它使GE Fanuc工业控制器能够利用以太网网络协议的速度和易于部署。它作为工厂仪表协议网络设备运行，频率为2.5 MHz，通过以太网布线和电路，可以以比任何其他工业协议更快的速度处理更大的带宽。GE Fanuc IC693BEM335以太网网络接口模块允许用户在GE Fanuc系列90-30 plc与各种不同的现场设备之间交换数据，例如来自开关和传感器的离散信号或来自发射器的模拟信号。

GE Fanuc IC693BEM335以太网网络接口模块的供电需要5v直流电源，将其插入GE Series 90-30底板即可获得。此操作应在PLC处于off状态时执行，因为不允许进行热插拔操作。两个9针，d型，串口位于GE Fanuc IC693BEM335以太网网络接口模块的前面，用于连接FIP总线或分支到系列90-30 plc。另一个具有15个引脚的串行端口用于通过运行GE发那科专有配置软件的个人计算机更新模块的固件。该模块不是为连接到网络的I/O设备供电设计的。鉴于其低IP等级(IP 20)和开放式结构，GE Fanuc IC693BEM335以太网网络接口模块应安装在保护面板内，以最大限度地提高其性能和使用寿命。

IC693BEM335 可编程逻辑控制器 以太网网络接口模块

【英文介绍】

The GE Fanuc IC693BEM335 Ethernet network interface module for the 90-30 series Programmable Logic Controllers (PLCS) enables GE Fanuc industrial controllers to take advantage of the speed and ease of deployment of the Ethernet network protocol. It operates as a factory instrumentation Protocol network device with a frequency of 2.5 MHz and, through Ethernet wiring and circuitry, can handle greater bandwidth at a faster speed than any other industrial protocol. The GE Fanuc IC693BEM335 Ethernet network interface module allows users to exchange data between the GE Fanuc series 90-30 PLCS and a variety of different field devices, such as discrete signals from switches and sensors or analog signals from transmitters.

The GE Fanuc IC693BEM335 Ethernet network interface module requires a 5v DC power supply, which can be obtained by plugging it into the GE Series 90-30 baseplate. This operation should be performed when the PLC is off, because hot swap is not allowed. Two 9-pin, type d, serial ports are located on the front of the GE Fanuc IC693BEM335 Ethernet network interface module for connection to the FIP bus or branch to the series 90-30 plc. Another 15-pin serial port is used to update the module's firmware through personal computers running GE Fanuc's proprietary configuration software. The module is not designed to power I/O devices connected to the network. Given its low IP rating (IP 20) and open construction, the GE Fanuc IC693BEM335 Ethernet network interface module should be installed inside the protection panel to maximize its performance and service life.

IC693BEM335 可编程逻辑控制器 以太网网络接口模块

【其他型号推荐】