IS220PAICH2A GE 模拟I/O包

IS220PAICH2A GE  模拟I/O包

IS220PAICH2A GE  模拟I/O包

环境温度范围-22至149°F

I类，2分区，A, B, C, D组-2015 - 12.01

功能缩写/缩写paic

制造商美国通用电气公司，通用电气工业系统

模型类型模拟I/O包

无害认证ul E207865

部件编号IS220PAICH2A

电源最小27.4 VDC，标称28.0 VDC，最大28.6 VDC

IS220PAICH2A型号被描述为模拟I/O包，已被批准用于危险和非危险场所。在模型的正面，有四个指标。底部还有一个端口，它被描述为I/O端口。有几种电压可以与PAIC包一起使用，PAIC包的最小电压是27.4伏的直流电。

由于IS220PAICH2A包能够在许多地方使用，因此有各种与IS220PAICH2A包相关的认证，其中一些是危险场所，一类区域二组IIC，一类区域二组a, B, C, D和ATEX区域二，IIC组和非危险场所也是如此。以下认证用于地点，UL E207685和UL DEMKO 12 ATEX 1114875X，请注意UL E207685认证用于许多地点。

有三种型号可以与IS220PAICH2A单元一起使用，即IS220PAICH2A和IS220PAICH2A以及IS220PAICH2A型号。所有这些型号都被称为输入输出端子板。

pac I/O包的典型位置是在两个可用的VME机架中的一个，即13个或21个插槽机架。请注意，该单元通常将与三重模块化冗余架构系统一起使用。在TMR系统中，有独立的控制模块、I/O网络和主处理器卡。

IS220PAICH2A GE  模拟I/O包

Ambient temperature range -22 to 149°F

Class I, 2 partitions, Groups A, B, C, D - 2015-12.01

Function abbreviation/abbreviation paic

Manufacturer General Electric, General Electric Industrial Systems

Model type emulates I/O packets

Harmless Certification ul E207865

Component number IS220PAICH2A

Power supply minimum 27.4 VDC, nominal 28.0 VDC, maximum 28.6 VDC

The IS220PAICH2A model is described as an analog I/O package and has been approved for use in hazardous and non-hazardous locations. On the front side of the model, there are four indicators. There is also a port on the bottom, which is described as an I/O port. There are several voltages that can be used with the PAIC package, the minimum voltage of the PAIC package is 27.4 volts of direct current.

Since IS220PAICH2A packages are capable of being used in many places, there are various certifications associated with IS220PAICH2A packages, some of which are hazardous places, Category 1 Area 2 Group Iics, Category 1 Area 2 Group a, B, C, D and ATEX Area 2, IIC Group and non-hazardous places as well. The following certifications are used for locations, UL E207685 and UL DEMKO 12 ATEX 1114875X, please note that UL E207685 certifications are used for many locations.

There are three models that can be used with IS220PAICH2A units, namely IS220PAICH2A and IS220PAICH2A and IS220PAICH2A models. All of these models are referred to as input/output terminals.

The typical location for pac I/O packets is in one of the two available VME racks, i.e. 13 or 21 slot racks. Note that this unit will typically be used with a triple modular redundant architecture system. In the TMR system, there are independent control modules, I/O networks and main processor cards.

IS220PAICH2A GE  模拟I/O包