DS200IMCPG1C 驱动控制板 连接器

☆型号：DS200IMCPG1C 驱动控制板 连接器

【产品详情】

GE IAC2000I电源接口板DS200IMCPG1C可以通过电缆连接到DS200SDCC驱动控制板。将电缆连接到驱动器控制板上的 1PL 连接器。GE IAC2000I 电源接口板DS200IMCPG1C有 8 个保险丝，可保护板组件免受过压情况的影响。更换电路板时，请检查熔断的保险丝，以获取有关用作更换保险丝的保险丝类型的信息。您还可以参考电路板随附的书面信息，以获取更换保险丝的列表。

确保只更换完全匹配的保险丝。未能使用完全匹配可能会导致电路板上的组件因承受高电压而损坏。很容易识别熔断的保险丝，因为在熔断的保险丝中，保险丝内部的触点已经熔化。更换保险丝只需将保险丝从连接器中拉出，然后按下连接器中的更换件即可。

☆型号：DS200IMCPG1C 驱动控制板 连接器

【英文介绍】

The GE IAC2000I power interface board DS200IMCPG1C can be connected to the DS200SDCC drive control board through cables. Connect the cable to the 1PL connector on the driver control board. The GE IAC2000I power interface board DS200IMCPG1C has eight fuses to protect the board components from overvoltage conditions. When replacing a circuit board, check the blown fuse for information about the type of fuse used to replace the fuse. You can also refer to the written information that comes with the board for a list of replacement fuses.

Make sure to replace only fuses that match exactly. Failure to use a full match may cause the components on the board to be damaged by being subjected to high voltage. It is easy to identify a blown fuse because in a blown fuse, the contacts inside the fuse have melted. To replace a fuse, simply pull the fuse out of the connector and press the replacement in the connector.

☆型号：DS200IMCPG1C 驱动控制板 连接器

【其他型号推荐】