DS200TBCAG1AAB GE模拟I/O端子板 驱动器连接到电流时

☆型号：DS200TBCAG1AAB GE模拟I/O端子板 驱动器连接到电流时

【产品详情】

GE 模拟 I/O 端子板DS200TBCAG1AAB具有 2 块 90 个信号线端子和 2 个 50 针连接器。 更换GE模拟I/O端子板DS200TBCAG1AAB是一个简单的过程，前提是您可以将信号线从旧板上的接线端子移动到更换板上的接线端子。

只有合格的服务人员才能执行此任务，因为当驱动器连接到电流时，驱动器中所含的能量很高。断开变频器与为符合当地和国家电气标准而安装的电源的连接。驱动器连接到电源，该电源将交流电源转换为用于运行驱动器的直流电源。

找到连接到驱动器的紧急断电设备也很重要。在紧急情况下，至少有两个人负责更换是很重要的。如果发生紧急情况，可以使用紧急切断装置寻求帮助以呼叫紧急援助或关闭电源。

首先，如果可能的话，移除信号线仍然连接的有缺陷的电路板，并将其放置在干净稳定的表面上，下面有 EDS 保护表面。例如，扁平的静电保护袋。戴上腕带，将更换板放在旧板旁边。一次将信号线从旧板移动到新板。

☆型号：DS200TBCAG1AAB GE模拟I/O端子板 驱动器连接到电流时

【英文介绍】

The GE analog I/O terminal board DS200TBCAG1AAB has two 90 signal line terminals and two 50-pin connectors. Replacing the GE analog I/O terminal board DS200TBCAG1AAB is a simple process, provided that you can move the signal cable from the terminal on the old board to the terminal on the replacement board.

Only qualified service personnel can perform this task because the energy contained in the drive is high when it is connected to the current. Disconnect the inverter from the power supply installed to comply with local and national electrical standards. The driver is connected to a power supply that converts the AC power to the DC power used to run the driver.

It is also important to find the emergency power outage device connected to the drive. In an emergency, it is important to have at least two people in charge of the replacement. In the event of an emergency, you can use the emergency cutoff device to call for emergency assistance or turn off the power.

First, if possible, remove the defective circuit board where the signal wires are still connected and place it on a clean and stable surface with an EDS protected surface underneath. For example, flat electrostatic bags. Put on the wristband and place the replacement plate next to the old one. Move the signal line from the old board to the new board at once.

☆型号：DS200TBCAG1AAB GE模拟I/O端子板 驱动器连接到电流时

【其他型号推荐】